Dodge Challenger ONLY. Includes one custom tail light divider 1/16 inch thick
Our Tail Light Dividers are the BEST dividers on Earth. Nobody else comes close, as everyone makes vinyl dividers unlike our high quality physical dividers. These are ONLY for 2015+ Challengers, these will NOT fit ANY Chargers. Tail light dividers are only for Challengers as the tail lamps are split and the dividers fits the flat surface in between.
All you must do is submit a photo to the checkout page. Once we receive your order, we will reach out to you to go over the design. The attached photo does not have to be anywhere near the final look of what you want. Just enough so we have an idea of what you are asking for.
WE NEVER CUT THE DESIGN UNTIL YOU APPROVE THE RENDER.
Install Instructions 🛠️:
For non ultra gloss tail light dividers:
To install, place a sliver of 3m in each corner and one piece in the center. Just a small piece approx 1 inch long will work or you can put adhesive on the entire back if you choose. Any automotive 3m will work. If you have a Non Ultra gloss divider, make sure to remove the brown paper backing from the divider first before you apply the adhesive.
If you have Ultra Gloss tail divider:
IF you have an ultra gloss, it will not have paper, the backside of the divider will look white. Just apply the adhesive directly to the white surface. DONT attempt to peel the white surface as that is not to be removed. It is imperative to create a good seal with the adhesive behind the tail light divider has to prevent moisture from getting behind the tail light divider. We recommend covering up as much as you can on the backside with adhesive so You want to put as much adhesive on the backside to cover up as much as possible versus our non-gloss where you can get away with putting a couple of slivers of 3M in the corners - It’s important to get a good amount of adhesive behind since the design is painted on The underside of the ultra gloss material where it will be making contact with the vehicle so you want To ensure that You are using enough adhesive on the back so that water won’t get behind the tail light divider.
🚨 You WILL need to remove the factory Dodge lettering And you will need to add your adhesive as explained above 🚨
DISCLAIMER: The Design in photos are EXAMPLE only and are not the actual Design being sold. Your design will be built with you through a render approval process.
WE NEVER CUT THE DESIGN UNTIL YOU APPROVE THE RENDER.
**********************************************************
Disclaimer:
Items on this website, unless otherwise stated, displayed in conjunction with or involving the use of any recognized trademark or copyright, are not represented as being approved by or affiliated with their respective owners, nor or they represented as being available for purchase. Images found on this website are for informational display purposes only. Any person submitting a request for such items, will be asserting themselves to have express permission from the mark owning company.
********************************************************
